Maximum quantity allowed is 999
请选择数量
CAS RN: 73183-34-3 | 產品號碼: B1964
Bis(pinacolato)diboron
×
![]()
×
* 以上價格已含運費關稅等但一些需要海運以及乾冰運輸的產品除外,詳情請與
當地經銷商
洽詢。
* TCI會時常優化儲存條件,儲存溫度請以在線目錄為準，敬請留意。
| 產品號碼 | B1964 |
| 純度/分析方法 | >99.0%(GC) |
| 分子式 / 分子量 | C__1__2H__2__4B__2O__4 = 253.94 |
| 外觀與形狀（20°C） | Solid |
| 儲存條件 | Refrigerated (0-10°C) |
| 儲存在惰性氣體下 | Store under inert gas |
| 應避免的情況 | Moisture Sensitive,Heat Sensitive |
| 包裝和容器 | 1G-Glass Bottle with Plastic Insert （閲覽圖片） |
| CAS RN | 73183-34-3 |
| Reaxys-RN | 7703552 |
| PubChem Substance ID | 87564847 |
| Merck Index(14) | 1300 |
| MDL編號 | MFCD00799570 |
產品規格
| Appearance | White to Almost white powder to crystal |
| Purity(GC) | min. 99.0 % |
| Melting point | 135.0 to 142.0 °C |
| Solubility in Methanol | almost transparency |
性質
| 熔點 | 138 °C |
| 溶解性（可溶於） | Ethanol, Benzene, Methanol |
GHS
| 圖形表示 |
|
| 信號詞 | Warning |
| 危險性說明 | H302 + H312 + H332 : Harmful if swallowed, in contact with skin or if inhaled. H315 : Causes skin irritation. H319 : Causes serious eye irritation. |
| 防範說明 | P501 : Dispose of contents/ container to an approved waste disposal plant. P261 : Avoid breathing dust/ fume/ gas/ mist/ vapors/ spray. P270 : Do not eat, drink or smoke when using this product. P271 : Use only outdoors or in a well-ventilated area. P264 : Wash skin thoroughly after handling. P280 : Wear protective gloves/ protective clothing/ eye protection/ face protection. P337 + P313 : If eye irritation persists: Get medical advice/ attention. P305 + P351 + P338 : IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P362 + P364 : Take off contaminated clothing and wash it before reuse. P332 + P313 : If skin irritation occurs: Get medical advice/ attention. P301 + P312 + P330 : IF SWALLOWED: Call a POISON CENTER/doctor if you feel unwell. Rinse mouth. P302 + P352 + P312 : IF ON SKIN: Wash with plenty of water.Call a POISON CENTER/doctor if you feel unwell. P304 + P340 + P312 : IF INHALED: Remove person to fresh air and keep comfortable for breathing. Call a POISON CENTER/doctor if you feel unwell. |
相關法規
運輸資料
| HS編碼* | 2920.90-000 |
Application
TCI Practical Example: Diborylation of Alkynes with a Platinum Catalyst
Used Chemicals
Procedure
To a degassed solution of diphenylacetylene (100 mg, 0.561 mmol) and bis(pinacolato)diboron (144 mg, 0.567 mmol) in DMF (0.5 mL) and toluene (0.5 mL) was added Pt(PPh3)4 (2 mg, 0.25 mol%). The reaction mixture was heated to 80 °C for 24 hours. After this time, the reaction was diluted with toluene (10 mL) and washed with saturated aqueous NH4Cl (2 x 10 mL). The organic phase was dried over MgSO4 and concentrated under reduced pressure. Recrystallization from MeOH afforded 1 as a white solid (241 mg, 0.558 mmol, 99%).
Experimenter’s Comments
The reaction mixture was monitored by TLC (CH2Cl2:hexane = 2:1, Rf = 0.45).
Analytical Data（Compound 1）
1H NMR (400 MHz, CDCl3); δ 7.02-7.09 (m, 6H), 6.94-6.96 (m, 4H), 1.32 (s, 24H).
13C NMR (101 MHz, CDCl3); δ 141.3, 129.3, 127.4, 125.8, 84.1, 24.9.
Lead Reference
- Platinum(0)-catalyzed diboration of alkynes
Other References
- Divergent and Stereoselective Synthesis of Tetraarylethylenes from Vinylboronates
Application
TCI Practical Example: Miyaura-Ishiyama Borylation using Pd(OAc)2
Used Chemicals
Procedure
To the solution of 3-iodobenzalehyde (1.16 g, 5.00 mmol) in dry DMF (15.0 mL) were added potassium acetate (981 mg, 10.0 mmol), palladium(II) acetate (112 mg, 0.500 mmol, 10 mol%) and bis(pinacolato)diborane (1.27 g, 5.00 mmol). The reaction mixture was stirred at 80 ºC for 7 h. The reaction mixture was cooled to room temperature and quenched with H2O (15 mL) and saturated NH4Cl aq. (10 mL), then the mixture was extracted twice with hexane : EtOAc = 4 : 1. The combined organic layer was washed with H2O (50 mL) and brine (50 mL), dried over Na2SO4, and concentrated under reduced pressure to afford the crude product as a yellow oil. The crude product was purified by column chromatography on silica-gel (hexane → hexane : EtOAc = 1:1) to afford 3-formylphenylboronic acid pinacol ester as a yellow oil (500 mg, 2.15 mmol, 43%).
Experimenter's Comments
(1) DMF was dried over molecular sieves.
(2) Completion of the reaction was confirmed by TLC (hexane : EtOAc = 1 : 1, Rf = 0.30) and GC.
Analytical Data（3-Formylphenylboronic Acid Pinacol Ester）
1H NMR (400 MHz, CDCl3); δ 10.1 (s, 1H), 8.30 (s, 1H), 8.06 (d, J = 4.0 Hz, 1H), 7.99 (ddd, J = 1.6, 1.8, 7.8 Hz, 1H), 7.53 (t, J = 8.0 Hz, 1H), 1.37 (s, 12H).
Lead Reference
- The bulky side chain of antillatoxin is important for potent toxicity: rational design of photoresponsive cytotoxins based on SAR studies
Application
Ni/Cu-Catalyzed Defluoroborylation of Fluoroarenes
Typical procedure (R = 4-Ph):
To a solution of 4-fluorobiphenyl (34.0 mg, 0.2 mmol, 1 eq.), bis(pinacolato)diboron (102 mg, 0.402 mmol, 2.0 eq.), copper iodide (7.6 mg, 0.04 mmol, 0.20 eq.), and cesium fluoride (91.0 mg, 0.6 mmol, 3.0 eq.) in toluene (0.5 mL) is added a solution of bis(1,5-cyclooctadiene)nickel(0) (5.1 mg, 0.02 mmol, 0.10 eq.) and tricyclohexylphosphine (28 mg, 99.8 µmol, 0.50 eq.) in toluene (0.5 mL) at room temperature. After stirring for 1 min at the same temperature, the mixture is heated at 80 °C with stirring for 20 h. After cooling to room temperature, saturated aqueous ammonium chloride (ca. 3 mL) is added to the mixture followed by extraction with EtOAc (ca. 3 mL × 3). The combined organic extract is dried over Na2SO4, and the filtrate is concentrated under reduced pressure. The residue is purified by preparative TLC (solvent: benzene/acetic acid = 20/1) to give 4-(4,4,5,5-tetramethyl-1,3,2-dioxaborolan-2-yl)biphenyl (55.6 mg, 0.198 mmol, 99% yield) as a colorless solid.
To a solution of 4-fluorobiphenyl (34.0 mg, 0.2 mmol, 1 eq.), bis(pinacolato)diboron (102 mg, 0.402 mmol, 2.0 eq.), copper iodide (7.6 mg, 0.04 mmol, 0.20 eq.), and cesium fluoride (91.0 mg, 0.6 mmol, 3.0 eq.) in toluene (0.5 mL) is added a solution of bis(1,5-cyclooctadiene)nickel(0) (5.1 mg, 0.02 mmol, 0.10 eq.) and tricyclohexylphosphine (28 mg, 99.8 µmol, 0.50 eq.) in toluene (0.5 mL) at room temperature. After stirring for 1 min at the same temperature, the mixture is heated at 80 °C with stirring for 20 h. After cooling to room temperature, saturated aqueous ammonium chloride (ca. 3 mL) is added to the mixture followed by extraction with EtOAc (ca. 3 mL × 3). The combined organic extract is dried over Na2SO4, and the filtrate is concentrated under reduced pressure. The residue is purified by preparative TLC (solvent: benzene/acetic acid = 20/1) to give 4-(4,4,5,5-tetramethyl-1,3,2-dioxaborolan-2-yl)biphenyl (55.6 mg, 0.198 mmol, 99% yield) as a colorless solid.
References
Application
C-H Borylation of Arenes
Typical Procedure:
A 25 mL-flask assembled a magnetic stirring bar, a septum inlet, and a condenser is charged with chloro(1,5-cyclooctadiene)iridium(I) dimer (10.1 mg, 0.015 mmol), 2,2’-bipyridyl (4.7 mg, 0.03 mmol), and bis-(pinacolato)diboron (254.0 mg, 1.0 mmol) and then flushed with nitrogen. An arene (60 mmol) is added, and the mixture is stirred at 80 °C for 16 h. The reaction mixture is analyzed by GC and GC mass spectroscopy. The product is extracted with benzene, washed with brine, and dried over MgSO4. Kugelrohr distillation gives analytically pure samples.
A 25 mL-flask assembled a magnetic stirring bar, a septum inlet, and a condenser is charged with chloro(1,5-cyclooctadiene)iridium(I) dimer (10.1 mg, 0.015 mmol), 2,2’-bipyridyl (4.7 mg, 0.03 mmol), and bis-(pinacolato)diboron (254.0 mg, 1.0 mmol) and then flushed with nitrogen. An arene (60 mmol) is added, and the mixture is stirred at 80 °C for 16 h. The reaction mixture is analyzed by GC and GC mass spectroscopy. The product is extracted with benzene, washed with brine, and dried over MgSO4. Kugelrohr distillation gives analytically pure samples.
References
- Mild iridium-catalyzed borylation of arenes. High turnover numbers, room temperature reactions, and isolation of a potential intermediate
Application
Diastereoselective Synthesis of Homoallyic Alcohols by Diboron-Promoted Coupling of Dienes and Aldehydes
References
- Diastereoselective Construction of Functionalized Homoallylic Alcohols by Ni-Catalyzed Diboron-Promoted Coupling of Dienes and Aldehydes
考研文獻
TCIMail
[TCIMAIL No.101] for Suzuki Cross-Coupling Reaction[Research Articles] Ni/Cu-Catalyzed Defluoroborylation of Fluoroarenes
產品文件 （部分產品的分析圖譜無法提供，敬請諒解。）
SDS
請選擇語言。
請求的SDS不可用。
如需更多幫助，請聯繫我們 。
產品規格
檢驗報告(CoA)及其他文檔
請輸入批號
輸入的批號不正確
示例 CoA
可下載CoA示例。注：該示例可能非最新批次的CoA。
目前沒有該產品的 CoA 示例。
分析圖譜
請輸入批號
輸入的批號不正確
很抱歉，您搜索的分析圖譜無法提供。