Maximum quantity allowed is 999
请选择数量
CAS RN: 2564-83-2 | 产品编码: T1560
2,2,6,6-Tetramethylpiperidine 1-Oxyl Free Radical
×
![]()
×
技术规格
| Appearance | Orange to Brown powder to crystal |
| Purity(GC) | min. 98.0 % |
| Purity(Iodometric Titration) | min. 98.0 % |
| Solubility in Methanol | almost transparency |
物性（参考值）
| 熔点 | 39 °C |
| 闪点 | 67 °C |
| 溶解性（可溶于） | 甲醇 |
GHS
| 象形图 |
|
| 信号词 | Danger |
| 危险性说明 | H314 : Causes severe skin burns and eye damage. |
| 防范说明 | P501 : Dispose of contents/ container to an approved waste disposal plant. P260 : Do not breathe dusts or mists. P264 : Wash skin thoroughly after handling. P280 : Wear protective gloves/ protective clothing/ eye protection/ face protection. P303 + P361 + P353 : IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower. P301 + P330 + P331 : IF SWALLOWED: Rinse mouth. Do NOT induce vomiting. P363 : Wash contaminated clothing before reuse. P304 + P340 + P310 : IF INHALED: Remove person to fresh air and keep comfortable for breathing. Immediately call a POISON CENTER/doctor. P305 + P351 + P338 + P310 : IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER/doctor. P405 : Store locked up. |
相关法规
| RTECS# | TN8991900 |
运输信息
| UN编号 | UN3263 |
| 类别 | 8 |
| 包装类别 | II |
| HS编码* | 2933.39-000 |
应用
TCI Practical Example: TEMPO Oxidation Utilizing Iodobenzene Diacetate as a Reoxidant
-
Used Chemicals
-
Procedure
-
To a solution of 1-naphthalenemethanol (306 mg, 2.0 mmol) in dichloromethane (2 mL, 1.0 mol/L) was added TEMPO (31.2 mg, 0.20 mmol), PhI(OAc)2 (709mg, 2.2 mmol) and the mixture was stirred at room temperature for 4 hours. Dichloromethane (12.5 mL), saturated aqueous sodium thiosulfate solution (12.5 mL) was added and the mixture was stirred for 30 minutes. The organic layer was washed with saturated aqueous sodium bicarbonate solution (10 mL), brine (10 mL) and the organic layer was dried over sodium sulfate and filtered. The solvent was removed under reduced pressure and the residue was purified by column chromatography (ethyl acetate:hexane = 0:100 - 3:97 on silica gel) to give 1-naphthaldehyde as a yellow liquid (291 mg, 93%).
-
Experimenter’s Comments
-
The reaction mixture was monitored by TLC (ethyl acetate:hexane = 1:9, Rf = 0.50).
-
Analytical Data
-
1-Naphthaldehyde
1H NMR (400 MHz, CDCl3); δ 10.41 (s, 1H), 9.26 (d, J = 8.9 Hz, 1H), 8.11 (d, J = 8.4 Hz, 1H), 8.01 (d, J = 6.8 Hz, 1H), 7.93 (d, J = 8.9 Hz, 1H), 7.74-7.57 (m, 3H).
-
Lead Reference
-
- 2-(Hydroxyimino)aldehydes: Photo- and Physicochemical Properties of a Versatile Functional Group for Monomer Design
应用
Nitroxyl-radical-catalyzed Oxidative Coupling of Amides with Silylated Nucleophiles
Typical Procedure:
To a solution of N-benzylbenzenesulfonamide (61.8 mg, 0.25 mmol), KBr (14.9 mg, 0.125 mmol), and Na2SO4 (71.0 mg, 0.50 mmol) in MeCN (1.5 mL) is added t-BuOCl (33.9 µL, 0.30 mmol) at room temperature, and the mixture is stirred at room temperature for 1 h. Then, TEMPO (7.8 mg, 0.050 mmol) is added and stirred at room temperature for 30 min. To the solution is added Na2CO3 (26.5 mg, 0.25 mmol), and the mixture is stirred at room temperature for 20 h. Subsequently, TMSCN (93.8 mL, 0.75 mmol) and LiClO4 (2.7 mg, 0.025 mmol) are added to the reaction mixture, and further stirred at room temperature for 22 h. Saturated Na2SO3 aqueous solution (10 mL) is added to the mixture, and the product is extracted with AcOEt (15 mL×3). The organic phase is washed with brine and dried over Na2SO4. The organic phase is concentrated under reduced pressure, and the crude product is purified by column chromatography (hexane : AcOEt = 3 : 1) to give the desired product (67.4 mg, Y. 99%).
To a solution of N-benzylbenzenesulfonamide (61.8 mg, 0.25 mmol), KBr (14.9 mg, 0.125 mmol), and Na2SO4 (71.0 mg, 0.50 mmol) in MeCN (1.5 mL) is added t-BuOCl (33.9 µL, 0.30 mmol) at room temperature, and the mixture is stirred at room temperature for 1 h. Then, TEMPO (7.8 mg, 0.050 mmol) is added and stirred at room temperature for 30 min. To the solution is added Na2CO3 (26.5 mg, 0.25 mmol), and the mixture is stirred at room temperature for 20 h. Subsequently, TMSCN (93.8 mL, 0.75 mmol) and LiClO4 (2.7 mg, 0.025 mmol) are added to the reaction mixture, and further stirred at room temperature for 22 h. Saturated Na2SO3 aqueous solution (10 mL) is added to the mixture, and the product is extracted with AcOEt (15 mL×3). The organic phase is washed with brine and dried over Na2SO4. The organic phase is concentrated under reduced pressure, and the crude product is purified by column chromatography (hexane : AcOEt = 3 : 1) to give the desired product (67.4 mg, Y. 99%).
References
应用
Catalytic Oxidation
References
- Indirect electrooxidation of alcohols
- Selective oxidation of monosaccharide derivatives
- Alcohol oxidation in an N-oxoammonium salts-NaBrO2 system
- Alcohol oxidation using organic oxoammonium salts
- Alcohol oxidation with oxygen and cupric ion
- Review
参考文献
产品文档 (部分产品的分析图谱无法提供，敬请谅解。)
化学品安全说明书(SDS)
请选择语言。
如需更多帮助，请联系我 们。
技术规格
CoA及其他文档
请输入批号
批号输入有误。请输入中横线前的4-5个字母数字字符。
示例 CoA
可下载CoA示例。注：该示例不一定是最新批次的CoA。
目前没有该产品的 CoA 示例。
分析图谱
请输入批号
批号输入有误。请输入中横线前的4-5个字母数字字符。
很抱歉，您搜索的分析图谱无法提供。
其他文件
相关产品
2,2,6,6-Tetramethylpiperidine 1-Oxyl Free Radical (purified by sublimation)
| 产品 | T3751 |
| CAS RN | 2564-83-2 |
| 纯度/分析方法 | >99.0%(GC)(T) |